Skyjack SJ6826RT - Section 5 - Procedures; 5.1 Safety and Workmanship

143
SJ6826RT, SJ6832RT
213560ABA
Engine Section 5 – Procedures
5.3 Engine
5.3-1 Kubota Dual Fuel (DF972 / WG752)
Resistance Checks
Resistance of Pick-Up Sensor
1. Disconnect the connector.
2. Measure the resistance with the ohmmeter.
3. If the resistance is not within the factory
specications, replace it.
Resistance Factory Spec. A-B 1.85 to 2.45 Ω at 20°C
1451AB
A
B
Resistance of Ignition Coil
1. Disconnect the connector.
2. Measure the resistance with an ohmmeter.
3. If the resistance is not within the factory
specications, replace it.
Resistance Factory Spec. A-B 1.87 to 2.53 Ω at 20°C
A-C 10.4 to 15.6 Ω at 20°C
1452AB
A: Terminal (+) C: High Tension Cord
B: Terminal (–)
B
C
A
Resistance of Ignitor
1. Disconnect the connector.
2. Measure the resistance with an ohmmeter.
3. If the resistance is not within the factory
specications, replace it.
A
G
C
E
B
H
D
F
(1)
IMPORTANT
To replace the ignitor with a service part, make
sure the ignitor has the same part cord No / ID
mark as the old one. (See the information label 1.)
To order go to Discount-Equipment.com