C
ONFIGURING
THE
S
WITCH
2-76
(port or trunk) on your switch, you can manually configure that interface
to join all the current multicast groups. This can ensure that multicast
traffic is passed to all the appropriate interfaces within the switch.
Command Attributes
• Interface – Activates the Port or Trunk scroll down list.
• VLAN ID – Selects the VLAN to propagate all multicast traffic coming
from the attached multicast router/switch.
• Port or Trunk – Specifies the interface attached to a multicast router.
Web – Click IGMP/Static Multicast Router Port Configuration. Specify
the interfaces attached to a multicast router, indicate the VLAN which will
forward all the corresponding multicast traffic, and then click “Add.” After
you have completed adding interfaces to the list, click “Apply.”
CLI – This example configures port 11 as a multicast router port within
VLAN 1.
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11 3-118
Console(config)#exit
Console#show ip igmp snooping mrouter vlan 1 3-119
VLAN M'cast Router Port Type
---- ------------------ -------
1 Eth 1/11 Static
To Next Page
Need help?
General
