C
OMMAND
L
INE
I
NTERFACE
3-56
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or a virtual terminal.
Note that Telnet is considered a virtual terminal connection, and the only
commands that apply to Telnet include exec-timeout and
password-thresh.
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode
GC 3-57
login Enables password checking at login LC 3-58
password Specifies a password on a line LC 3-59
exec-timeout Sets the interval that the command interpreter
waits until user input is detected
LC 3-60
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC 3-61
silent-time Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command
LC 3-62
databits Sets the number of data bits per character that
are interpreted and generated by hardware
LC 3-63
parity Defines the generation of a parity bit LC 3-64
speed Sets the terminal baud rate LC 3-64
stopbits Sets the number of the stop bits transmitted
per byte
LC 3-65
show line Displays a terminal line's parameters NE,
PE
3-66
To Next Page
Loading...
Need help?
General
