IP C
OMMANDS
3-55
Command Usage
• Use the ping command to see if another site on the network can be
reached.
• Following are some results of the ping command:
• Normal response -The normal response occurs in one to ten seconds,
depending on network traffic.
• Destination does not respond - If the host does not respond, a “timeout”
appears in ten seconds.
• Destination unreachable - The gateway for this destination indicates that
the destination is unreachable.
• Network or host unreachable - The gateway found no corresponding
entry in the route table.
• Press <Esc> to stop pinging.
Example
Related Commands
interface
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5
seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
To Next Page
Loading...
Need help?
General
