SMC Networks SMC6750L2

C OMMAND L INE I NTERFACE
3-82
bridge-group aging-time
Use this command to set the aging time for entries in the address table.
Use the no form to restore the default aging time.
Syntax
bridge-group bridge-group aging-time seconds
no bridge-group bridge-group aging-time
• bridge-group - Bridge group index (bridge 1).
• seconds - Time is number of seconds (10-1000000).
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding
information.
Example
show bridge group aging-time
Use this command to show the aging time for entries in the address table.
Syntax
show bridge group bridge-group aging-time
bridge-group - Bridge group index (bridge 1)
Default Setting
None
Console(config)#bridge-group 1 aging-time 100
Console(config)#