SMC Networks SMC6750L2

C ONFIGURING THE S WITCH
2-50
Adding Interfaces Based on Static Membership
Command Attributes
• Interface – Port or trunk identifier.
• Member – VLANs for which the selected interface is a tagged
member.
• Non-Member – VLANs for which the selected interface is not a
tagged member.
Web – Open VLAN/VLAN Static Membership. Select an interface from
the scroll-down box (Port or Trunk). Click “Query” to display VLAN
membership information for the interface. Select a VLAN ID, and then
click “Add” to add the interface as a tagged member, or click “Remove” to
remove the interface. After configuring VLAN membership for each
interface, click “Apply.”
CLI – This example adds Port 3 to VLAN 1 as a tagged port, and removes
Port 3 from VLAN 2.
Console(config)#interface ethernet 1/3 3-68
Console(config-if)#switchport allowed vlan add 1 tagged 3-101
Console(config-if)#switchport allowed vlan remove 2