SMC Networks SMC6750L2

P ORT C ONFIGURATION
2-27
- Sym - Transmits and receives pause frames for flow control (Gigabit
Ethernet ports only)
- FC - Supports flow control
• Trunk – Indicates if a port is a member of a trunk. To create trunks
and select port members, see “Port Trunk Configuration” on page
2-66.
Note: Autonegotiation must be disabled before you can configure or
force the interface to use the Speed/Duplex Mode or Flow
Control options.
Web – Click Port/Port Configuration or Trunk Configuration. Modify the
required interface settings, and click “Apply.”
CLI – Select the interface, and then enter the required settings.
Console(config)#interface ethernet 1/13 3-68
Console(config-if)#description RD SW#13 3-68
Console(config-if)#shutdown 3-73
.
Console(config-if)#no shutdown
Console(config-if)#no negotiation 3-70
Console(config-if)#speed-duplex 100half 3-69
Console(config-if)#flowcontrol 3-72
.
Console(config-if)#negotiation
Console(config-if)#capabilities 100half 3-71
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol