SMC Networks SMC6750L2

C OMMAND L INE I NTERFACE
3-62
silent-time
Use this command to set the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command. Use the no form to
remove the silent time value.
Syntax
silent-time seconds
no silent-time
seconds - The number of seconds to disable console response.
(Range: 0-65535; 0: no silent-time)
Default Setting
The default value is no silent-time.
Command Mode
Line Configuration
Command Usage
If the password threshold was not set with the password-thresh
command, silent-time begins after the default value of three failed
logon attempts.
Example
To set the silent time to 60 seconds, enter this command:
Related Commands
password-thresh
Console(config-line)#silent-time 60
Console(config-line)#