IGMP S
NOOPING
C
OMMANDS
3-111
ip igmp snooping vlan static
Use this command to add a port to a multicast group. Use the no form to
remove the port.
Syntax
ip igmp snooping vlan vlan-id static ip-address interface
no ip igmp snooping vlan vlan-id static ip-address interface
• vlan-id - VLAN ID (Range: 1-4094)
• ip-address - IP address for multicast group
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a
port:
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet
1/5
Console(config)#
To Next Page
Loading...
Need help?
General
