SMC Networks SMC6750L2

M ANAGING F IRMWARE
2-19
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
Setting the Startup Configuration File
If you download to a new file name, then select the new file from the
drop-down box, and click “Apply Changes.”
To use the new settings, reboot the system.
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch.
Note: The CLI allows you replace a running configuration file without
performing a reset.
Console#copy tftp startup-config 3-18
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
/
Console#
Console#copy tftp startup-config 3-18
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
/
Console#
Console#config
Console(config)#boot system config: startup2.0 3-23
Console(config)#exit
Console#reload