C
OMMAND
L
INE
I
NTERFACE
3-4
You can enter commands as follows:
• To enter a simple command, enter the command keyword.
• To enter multiple commands, enter each command in the required
order. For example, to enable Privileged Exec command mode, and
display the startup configuration, enter:
Console>enable
Console#show startup-config
• To enter commands that require parameters, enter the required
parameters after the command keyword. For example, to set a
password for the administrator, enter:
Console(config)#username admin password 0 smith
Minimum Abbreviation
The CLI will accept a minimum number of characters that uniquely
identify a command. For example, the command “configure” can be
entered as config. If an entry is ambiguous, the system will prompt for
further input.
Command Completion
If you terminate input with a Tab key, the CLI will print the remaining
characters of a partial keyword up to the point of ambiguity. In the
“logging console” example, typing log followed by a tab will result in
printing the command up to “logging.”
Getting Help on Commands
You can display a brief description of the help system by entering the help
command. You can also display command syntax by using the “?”
character to list keywords or parameters.
To Next Page
Loading...
Need help?
General
