B
ASIC
C
ONFIGURATION
1-11
Trap Receivers
You can also specify SNMP stations that are to receive traps from the
switch.
To configure a trap receiver, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt,
type “snmp-server host host-address community-string,” where
“host-address” is the IP address for the trap receiver and
“community-string” is the string associated with that host. Press
<Enter>.
2. In order to configure the switch to send SNMP notifications, you must
enter at least one snmp-server enable traps command. Type
“snmp-server enable traps type,” where “type” is either
authentication or link-up-down. Press <Enter>.
Saving Configuration Settings
Configuration commands only modify the running configuration file and
are not saved when the switch is rebooted. To save all your configuration
changes in nonvolatile storage, you must copy the running configuration
file to the start-up configuration file using the “copy” command.
To save the current configuration settings, enter the following command:
1. From the Privileged Exec mode prompt, type “copy running-config
startup-config” and press <Enter>.
2. Enter the name of the start-up file. Press <Enter>.
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Console#copy running-config startup-config
Startup configuration file name []: startup
Console#
To Next Page
Loading...
Need help?
General
