IGMP S
NOOPING
C
OMMANDS
3-113
Command Mode
Privileged Exec
Example
The following shows the current IGMP snooping configuration:
show bridge multicast
Use this command to show known multicast addresses.
Syntax
show bridge bridge-group multicast [vlan vlan-id]
[user | igmp-snooping]
• bridge-group - Bridge group index.
• vlan-id - VLAN ID (1 to 4094)
• user - Display only the user-configured multicast entries.
• igmp-snooping - Display only entries learned through IGMP
snooping.
Default Setting
None
Command Mode
Privileged Exec
Console#show ip igmp snooping
Service status: Enabled
Querier status: Enabled
Query count: 2
Query interval: 125 sec
Query max response time: 10 sec
Query time-out: 300 sec
IGMP snooping version: Version 2
Console#
To Next Page
Loading...
Need help?
General
