MV-32/64 Multiviewer www.snellgroup.com Hydra Open Protocol
Issue 1 Rev 11 Page 109 © 2014 Snell Limited
…and the complete response is:
<XML>
<PACKET MODULE=”MV-32/MV-64” VERSION=”1.0”>
<TRANSACTIONRESULT SERIAL=”serial” ERROR=”error”>
<COMMANDRESULT SERIAL=”serial” ERROR=”error”>
…
</COMMAND>
…more <COMMANDRESULT> and </COMMANDRESULT> tags if more than one command was
sent
</TRANSACTIONRESULT>
</PACKET>
</XML>
A.5.1 Commands - Summary
The commands currently available are listed in the table below.
Command Description
adjustumd Updates the UMD text in an object
adjustborder Updates the border of an object
adjustbackground Updates the background of a text object
adjusttext Updates the lines in a text object
hidetext Hides a text object
getsourcetally Gets the state of a tally for a source
getversion Gets the version of firmware running
loadlayoutandupdate Load a layout and send it to the screen
setaudiomonitorsource Set the source of an audio monitor output
setobjectsource Set the source of a video object
setsourcename Sets the name (UMD) for a source
setsourcetally Sets the state of a tally for a source
Table 61. Available Commands
To Next Page
Loading...