Snell MV-32 - Network Tab; Data-XX Tab

MV-32/64 Multiviewer www.snellgroup.com Operation
Issue 1 Rev 11 Page 46 © 2014 Snell Limited
4.11.8 Network Tab
4.11.9 Data-xx Tab
The Data-xx tab is not used.
Fig 34. Module Properties - Network Tab.
Hostname Enter friendly name for MV-32/MV-64 multiviewer.
Use DHCP
Check to use DHCP for automatic acquisition of network settings. Un
check for entry of fixed network settings.
IP Address Enter fixed IP address, if required.
Netmask Enter network mask, if required.
Gateway Enter gateway address, if required.
DNS Server 1 Enter DNS server address, if required.
DNS Server 2 Enter DNS server address, if required.
Apply Applies fixed network settings to the frame.
SNMP Check required SNMP version.
Add Opens the dialog for entering SNMP IP address and adding it to list.
Delete Deletes selected SNMP IP address from the list.
Table 23. Module Properties - Network Tab.