Instruction Manual for AS380 Series Elevator Integrated Drive Controller
Chapter 6 Introduction to the supporting products
6.6.7.4 Electrical Specification
6.6.7.4.1 Switching Input
Table 6.20 The swiching input specification
Common anode, low level input is valid
Characteristic operating current
Maximum operating current
Isolated group (common port)
Input frequency
amplitude limiting
6.6.7.4.2 Communication Port
Table 6.21 The communication port specification
Maximum communication delay
6.6.7.4 Definitions of Input and Output Interfaces
Table 6.22 The definitions of the JP2 and JP3 port
Communication signal negative port of
No. 4 elevator in group control system
Communication signal positive port of
No. 4 elevator in group control system
Communication power negative port of
To Next Page
Loading...
Need help?
General
