Stober PS6A34 - X700: SD Slot

10 | Connection STOBER
136
02/2019 | ID 442728.05
10.5.19 X700: SD slot
The SD slot is used for data backup in the event of service. SD and SDHC cards with storage
capacity from 128MB to 32GB are supported. SDHC cards with a storage capacity of 64GB
can be used only if they have been first reformatted to max. 32GB. Since higher capacities
increase the controller starting time, STOBER recommends the use of cards with a storage
capacity from 2 to 4GB.
Information
The drive controller has internal configuration memory and can therefore be operated without an
inserted SD card. In the DS6 commissioning software, the action A00Save values always saves
both to internal configuration memory as well as the inserted SD card. Back up your
configuration to a SD card after completing commissioning in order to allow transfer of the
configuration to the replacement controller in the event of service. When switching on the
replacement controller, the data is loaded giving priority to the inserted SD card. To make a
non-volatile back-up in the internal configuration memory, you must run A00Save values.