Stober PS6A34 - List of Figures

List of figures STOBER
254
02/2019 | ID 442728.05
List of figures
Fig. 1 System overview for the multi-axis drive system with SI6 and PS6 ....................... 22
Fig. 2 PS6A24 nameplate................................................................................................. 23
Fig. 3 SI6A061 nameplate ................................................................................................ 27
Fig. 4 Sticker with MV and serial number ......................................................................... 28
Fig. 5 PS6 dimensional drawing ....................................................................................... 42
Fig. 6 Asymmetric load on double-axis controllers ........................................................... 48
Fig. 7 SI6 dimensional drawing......................................................................................... 53
Fig. 8 DL6B dimensional drawing..................................................................................... 55
Fig. 9 KWADQU 420×91 dimensional drawing................................................................. 66
Fig. 10 FZZMQU 400×65 dimensional drawing.................................................................. 68
Fig. 11 FGFKQU 31005 dimensional drawing .................................................................... 70
Fig. 12 Derating the nominal current depending on the clock frequency,
TEP3720-0ES41..................................................................................................... 72
Fig. 13 Derating the nominal current depending on the clock frequency,
TEP3820-0CS41..................................................................................................... 72
Fig. 14 Derating the nominal current depending on the clock frequency,
TEP4020-0RS41 .................................................................................................... 73
Fig. 15 Derating the nominal current based on surrounding temperature .......................... 73
Fig. 16 Derating the nominal current depending on installation elevation .......................... 74
Fig. 17 Derating the voltage depending on installation elevation ....................................... 74
Fig. 18 TEP dimensional drawing ....................................................................................... 75
Fig. 19 Grounding concept in mixed operation with powered PS6 supply module............. 79
Fig. 20 Annual reforming .................................................................................................... 86
Fig. 21 Reforming before commissioning ........................................................................... 87
Fig. 22 Voltage levels dependent on storage time.............................................................. 88
Fig. 23 Fields for equipment identification on the front of the device.................................. 89
Fig. 24 Minimum clearances............................................................................................... 92
Fig. 25 Drilling diagram for multi-axis drive system ............................................................ 93
Fig. 26 Determination of the correct length of the copper rails ........................................... 94
Fig. 27 Connection of the grounding conductor.................................................................. 107
Fig. 28 Connection of the grounding conductor.................................................................. 108
Fig. 29 Connection overview using the example of the PS6A34 ........................................ 110
Fig. 30 Connection overview using the example of the SI6A162 ....................................... 116
Fig. 31 TEP output choke connection example .................................................................. 139
Fig. 32 Shielded connection of the power cable (graphics: icotek GmbH) ......................... 139