STOBER 14 | Service
05/2019 | ID 442790.01
187
6. Online tab:
Click Set all to read in order to activate all drive controllers for read data synchronization.
7. Click Assign all based on reference to assign all drive controllers to the configured drive controllers.
8. Then click Establish online connection.
ð The data connection is established and the project configuration data is transmitted from the drive controllers to
the PC.
ð The drive controllers are created in the project tree and are active.
9. Then in the Assignment and live firmware update window > Online tab, click on Set all drive controllers to offline (with
reverse documentation).
10. Confirm the Reverse documentation dialog box with OK.
ð The connection is disconnected.
ð The drive controllers are write-protected (lock status with red R).
11. Save the project in a local directory and send the file to us.
To Next Page
Loading...
