Strasbaugh 7AA - CRT Display Menus

Operation and Maintenance Manual Model 7AA Wafer Grinder
4 - 10 Version 1.2 - April 18, 1996
CRT DISPLAY MENUS
Machine control parameters are divided into and accessed via
CRT display menus. The ten different menus are listed below:
Menu Where To Find Details - Manual
Location
1) Machine operation menu • Ch. 4, Operator Functions
2) Start up check list • Ch. 4, Operator Functions
3) Initialize machine • Ch. 4, Operator Functions
4) Parameter entry • Ch. 4, Operator Functions
5) Grind mode select • Ch. 4, Operator Functions
6) Manual jog • Ch. 7, Mechanical Maintenance
Procedures
7) Chuck grind • Ch. 7, Mechanical Maintenance
Procedures
8) Machine parameters • Ch. 5, Machine Setup
9) Adjust r.p.m.'s • Ch. 5, Machine Setup
10) Machine diagnostics • Ch. 8, Software Calibration
Procedures