2-10 SPARCstation 5 Model 110 Service Manual • November 1996
watch-aui Monitors broadcast Ethernet
packets (10BASE5—Thicknet) on
the Ethernet cable(s) connected to
the system.
Connect the system to the
network via the desired
Ethernet port.
See description.
watch-tpe Monitors broadcast Ethernet
packets (10BASET—Twisted Pair
Ethernet) on the Ethernet cable(s)
connected to the system.
Connect the system to the
network via the desired
Ethernet port.
See description.
watch-net-all Monitors broadcast Ethernet
packets on all Ethernet interfaces
installed in the system, one at a
time.
Connect the system to the
network via the desired
Ethernet port.
When an SBus card
network controller
card is installed.
probe-scsi Returns to the display the SCSI
devices (internal and external)
and their SCSI targets connected
to the built-in SCSI port.
Connect external SCSI
devices to the system and
turn on their power.
To determine if a
SCSI peripheral is
talking to the
system.
To determine the
SCSI targets
(addresses) of a
SCSI device.
To determine if
more than one SCSI
peripheral is
assigned the same
SCSI address.
To determine if the
built-in SCSI
controller is
defective.
probe-scsi-all Returns to the display the SCSI
devices and their SCSI targets
connected to all SCSI ports (both
the built-in SCSI port and any
additional SCSI host adapter
cards).
Connect external SCSI
devices to the system and
turn on their power.
See probe-scsi.
To determine if a
SCSI host adapter
controller is
defective.
power-off Powers off the system. You must have a Sun Type-5
keyboard in order to use this
command.
To power off the
system with a Sun
Type-5 keyboard.
TABLE 2-4 Selected FORTH Diagnostic Tests (Continued)
Type of Test Description Preparation When to Use
To Next Page
Loading...
