Chapter 5 Replacing Cold-Swappable FRUs 5-9
■ Section 5.2.11, “Removing the LED Board” on page 5-32 and Section 5.2.12,
“Replacing the LED Board” on page 5-33
■ Section 5.2.13, “Removing the Fan Power Board” on page 5-34 and Section 5.2.14,
“Replacing the Fan Power Board” on page 5-34
■ Section 5.2.15, “Removing the Front I/O Board” on page 5-35 and Section 5.2.16,
“Replacing the Front I/O Board” on page 5-36
■ Section 5.2.17, “Removing the DVD Drive” on page 5-37 and Section 5.2.18,
“Replacing the DVD Drive” on page 5-37
■ Section 5.2.19, “Removing the SAS Disk Backplane” on page 5-37 and
Section 5.2.20, “Replacing the SAS Disk Backplane” on page 5-38
■ Section 5.2.21, “Removing the Battery on the System Controller” on page 5-40 and
Section 5.2.22, “Replacing the Battery on the System Controller” on page 5-40
To locate these FRUs, refer to Appendix A.
5.2.1 Removing PCI-Express and PCI-X Cards
1. Perform the procedures described in Section 5.1, “Common Procedures for Parts
Replacement” on page 5-1.
2. Locate the PCI card that you want to remove.
To locate the PCI card slots, refer to
FIGURE 5-5 and FIGURE 5-6. The PCI card slots are
located on the I/O portion of the motherboard assembly.
FIGURE 5-5 Location of PCI-Express and PCI-X Card Slots
3. Note where the PCI card is installed, and note any cables so you know where to
reinstall the card and cables.
Slot 0
Slot 2
Slot 0
Slot 1
Slot 1
PCI-E slots PCI-X slots
To Next Page
Loading...
Need help?
General
