5-42 Sun Fire T2000 Server Service Manual • July 2007
3. Position the bezel on the front of the chassis and snap it into place.
4. Open the fan door.
5. Tighten the captive screw to secure the front bezel to the chassis.
5.3.2 Replacing the Top Cover
1. Place the top cover on the chassis.
Set the cover down so that it hangs over the rear of the server by about an inch.
2. Slide the cover forward until it latches into place.
5.3.3 Reinstalling the Server Chassis in the Rack
If you removed the server chassis from the rack, perform these steps.
Caution – The server weighs approximately 40 lb. (18 kg). Two people are required
to carry the chassis and install it in the rack.
1. Ensure that the rack rails are extended.
2. Place the ends of the chassis mounting brackets (inner section) into the slide rails
(
FIGURE 5-30).
To Next Page
Loading...
