Chapter 5 Replacing Cold-Swappable FRUs 5-37
6. Reconnect and secure the fan power board.
7. Replace all three fans.
See Section 4.2.2, “Replacing a Fan” on page 4-4.
8. Perform the procedures described in Section 5.3, “Common Procedures for
Finishing Up” on page 5-41.
5.2.17 Removing the DVD Drive
1. Perform the procedures described in Section 5.1, “Common Procedures for Parts
Replacement” on page 5-1.
2. Remove the DVD interconnect board from the back of the DVD drive.
3. Press the release latch and pull the DVD drive out of the chassis.
5.2.18 Replacing the DVD Drive
1. Slide the DVD drive into the front of the chassis.
2. Replace the DVD interconnect board on the back of the DVD drive.
3. Perform the procedures described in Section 5.3, “Common Procedures for
Finishing Up” on page 5-41.
5.2.19 Removing the SAS Disk Backplane
1. Perform the procedures described in Section 5.1, “Common Procedures for Parts
Replacement” on page 5-1.
2. Remove the DVD from the chassis.
See Section 5.2.17, “Removing the DVD Drive” on page 5-37.
3. Remove all hard drives from the chassis.
See Section 4.5.1, “Removing a Hard Drive” on page 4-9. Note the slot in which each
drive belongs.
4. Disconnect the SAS power cable from the power cable plug.
5. Note of which SAS data cable is plugged into which slot and disconnect the four
SAS data cables from the SAS disk backplane.
To Next Page
Loading...
