3-18 Sun Fire T2000 Server Service Manual • July 2007
3.3.1 Running ALOM CMT Service-Related Commands
This section describes the ALOM CMT commands that are commonly used for
service-related activities.
3.3.1.1 Connecting to ALOM CMT
Before you can run ALOM CMT commands, you must connect to the ALOM CMT.
There are several ways to connect to the system controller:
■ Connect an ASCII terminal directly to the serial management port.
■ Use the telnet command to connect to ALOM CMT through an Ethernet
connection on the network management port.
Note – Refer to the Advanced Lights Out Manager (ALOM) CMT Guide for
instructions on configuring and connecting to ALOM CMT.
3.3.1.2 Switching Between the System Console and ALOM CMT
■ To switch from the console output to the ALOM CMT sc> prompt, type #.
(Hash-Period).
■ To switch from the sc> prompt to the console, type console.
To Next Page
Loading...
