Index-5
reasons to run, 3-31
troubleshooting with, 3-6
Predictive Self-Healing (PSH)
about, 2-8, 3-40
clearing faults, 3-44
memory faults, and, 3-7
Sun URL, 3-41
procedures for finishing up, 5-41
procedures for parts replacement, 5-1
processor, 2-2
processor designation, 2-4
PROM, system configuration, 5-18
PS0/PS1 (power supply FRU names), A-5
PSH detected faults, 3-21
PSH see also Predictive Self-Healing (PSH), 3-40
Q
quick visual notification, 3-1
R
RAID (redundant array of independent disks)
storage configurations, 2-8
rear blower, A-5
hot-swapping, 4-7
removing, 4-7
replacing, 4-7
Rear Blower LED, 4-8
Rear FRU Fault LED, 3-10
rear panel
illustration, 2-9
LEDs, 3-9
reliability, availability, serviceability (RAS)
features, 2-6
remote management, 2-5
removefru command, 3-20, 4-5
removing
battery on the system controller, 5-40
DIMMs, 5-12
DVD drive, 5-37
fan power board, 5-34
front bezel, 5-7
front I/O board, 5-35
LED board, 5-32
motherboard assembly, 5-19
PCI-E and PCI-X cards, 5-9
power distribution board, 5-27
SAS disk backplane, 5-37
server from the rack, 5-4
system controller card, 5-17
top cover, 5-6
replacing
battery on the system controller, 5-40
DIMMs, 5-14
DVD drive, 5-37
fan power board, 5-34
front I/O board, 5-36
LED board, 5-33
motherboard assembly, 5-23
PCI cards, 5-11
power distribution board, 5-30
SAS disk backplane, 5-38
system controller card, 5-18
top cover, 5-42
top front cover and front bezel, 5-41
reset command, 3-20
resetsc command, 3-20
S
safety information, 1-1
safety symbols, 1-1
SAS controller, 6-1
SAS disk backplane, A-6
removing, 5-37
replacing, 5-38
SASBP (SAS disk backplane FRU name), A-6
SC (system controller card FRU name), A-4
SC/BAT (system controller battery FRU name), A-4
sc_servicemode parameter, 5-32
sensors, temperature, 2-7
serial number, chassis, 2-10
server
extending to maintenance position, 5-3
illustration, 2-2
locating, 3-10
returning to normal rack position, 5-43
weight, 5-4
Service Required LED, 3-10, 3-16, 3-40, 4-2
setcsn command, 5-31
setkeyswitch parameter, 3-20, 3-30, 5-15
setlocator command, 3-10, 3-20, 5-3
showcomponent command, 3-46, 3-47
showenvironment command, 3-20, 3-22, 4-6
To Next Page
Loading...
Need help?
General
