2-50 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
Specifying or Canceling prefer for NTP Server
■ Command operation
1. Use the showntp(8) command to display the prefer settings.
2. Use the setntp(8) command to set the prefer.
When you use the setntp(8) command to change the prefer, execute the
rebootxscf(8) command to apply the specified configuration and reset the
XSCF.
3. Use the showntp(8) command to confirm the prefer settings.
Note – The setting of the prefer by setntp(8) command is supported only on
M3000/M4000/M5000/M8000/M9000 servers that run certain versions of XCP
firmware (beginning with XCP 1082).
Changing Stratum Value for XSCF
■ Command operation
1. Use the showntp(8) command to display the stratum value for the XSCF
network.
XSCF> showntp -m
prefer : on
<Example 1> Specify prefer for NTP server
XSCF> setntp -m prefer=on
Please reset the XSCF by rebootxscf to apply the ntp settings.
<Example 2> Cancel prefer for NTP server
XSCF> setntp -m prefer=off
Please reset the XSCF by rebootxscf to apply the ntp settings.
XSCF> showntp -m
prefer : off
XSCF> showntp -a
server ntp1.red.com
server ntp2.blue.com
XSCF> showntp -s
stratum : 5
To Next Page
Loading...
