2-16 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
TABLE 2-2 lists setting items and the corresponding shell commands.
To complete the network settings, the XSCF reset is required. Reset the XSCF by
using the rebootxscf(8) command. After the XSCF is reset, the XSCF session is
disconnected. Please log in again to the XSCF.
TABLE 2-2 Network Configuration
Item Description Shell Command Remarks
Display network Displays XSCF network interfaces.
Also, displays the following network status:
• Number of bytes of the receive queue
buffer.
• Number of bytes of the send queue buffer.
• Local address and port.
• Host address and Socket port number.
shownetwork
showdscp
If the XSCF Unit is
redundant, the
connection status of the
other side is not
displayed.
Enable/disable
network
Enables or disables an XSCF network interface
(see
TABLE 2-1).
setnetwork
setdscp
• When the XSCF Unit is
a redundant model,
Defaults of IP address
of ISN are the
following:
XSCF#0:192.168.1.1
XSCF#1:192.168.1.2
• No default setting has
been specified for the
other interfaces.
• You can use a single
LAN port for
XSCF-LAN. For
network connection
examples, see
Chapter 3.
• You can remove the
configuration,
XSCF-LAN, Takeover
IP address, and
netmask
IP address Specifies the following IP address of the XSCF
network interfaces (see
TABLE 2-1).
• One or both of the XSCF-LAN ports
• DSCP
• ISN, Takeover IP address (if a redundant
XSCF Unit is used)
netmask Sets a netmask for an XSCF network interface.
Display host
name
Displays a host name and the host name
informations.
A Fully Qualified Domain Name (FQDN) can
be displayed
showhostname
To Next Page
Loading...
