Chapter 4 Operation of the Server 4-11
Note – In the M3000 server, the domain configuration policy can be changed by
using the setdcl(8) command. However, other domain configurations cannot be
changed.
Commands Used to Setup or Display Information
Execute the following commands individually, as appropriate. For details of these
commands, see Chapter 5.
■ setdcl
■ setupfru
■ addboard
■ deleteboard
■ moveboard
For details on adding or changing a domain, see Chapter 2 of the XSCF Reference
Manual or the Administration Guide.
For details on using the DR function to change the domain configuration, see the
Dynamic Reconfiguration User’s Guide.
4.4 Server and Domain Power Operations
This section describes power operations for servers and domains, and it explains
how to display the power status of a server or domain.
To perform the power operations, use the XSCF Shell commands.
Commands Used for the Operations or Status Display
Execute the following commands individually, as appropriate. For details of these
commands, see Chapter 5.
■ poweron
■ poweroff
■ reset
■ sendbreak
■ setpowerupdelay
To Next Page
Loading...
