Appendix B XSCF Log Information B-7
B.3 Event Log
When an event occurs in the server, such as when the system status changes, the
configuration is changed, the operator panel operated, or an event was sent to the
Solaris OS in the server or domain, the XSCF firmware collects an XSCF event log.
The field engineer and authorized service personnel use the XSCF event logs to
analyze a fault that occurs, investigate the server operation status, or reference the
history of maintenance operation. This section explains how to reference XSCF event
logs. See
TABLE 8-3 for the size and generation numbers of XSCF event logs.
Using the showlogs(8) Command to Reference XSCF Event Logs
● Specify the event option on the XSCF Shell and perform the showlogs(8)
command to reference XSCF event logs.
(The example is subject to change without previous notice for functional
improvement.)
In the example above, the following items are displayed:
■ Time at which each event log was gathered (Date). This is indicated in local time.
■ Event message (Message).
Switch status Meaning
Locked: The mode switch is locked.
Service: The mode switch is in service.
<Example> XSCF event logs are displayed as a list.
XSCF> showlogs event
Date Message
Mar 30 17:45:31 JST 2005 System power on
Mar 30 17:55:31 JST 2005 System power off
To Next Page
Loading...
