8-20 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
3. If the update has been performed, follow the procedure in Updating XCP From
External Media or Updating XCP From the Network to update XCP, and confirm
the version.
Confirming That the XSCF Firmware Is Updated When the MBU Is
Replaced (in the M3000 server)
1. Turn on power to the server after completing the Motherboard unit replacement
task.
2. If the replacement unit and the replaced unit have different versions, a message
is displayed.
3. If the update has been performed, follow the procedure in Updating XCP From
External Media or Updating XCP From the Network to update XCP, and confirm
the version.
8.1.11 If an Error Occurs During XSCF Firmware Update
If the system hangs or any of the messages shown below is output during the
firmware update, the XSCF Unit on the faulty side cannot be used and is treated as a
faulty component.
Try the firmware update again when an error occurs while updating the XSCF
firmware. The second attempt may succeed where the first failed.
â– Case where the XSCF Unit is redundantly configured (on M8000/M9000 servers)
Error involving a failed write or reset operation on the standby or active side
â– Case where there is one XSCF Unit (on M3000/M4000/M5000 servers)
Error involved a failed write or reset operation
8.1.12 Frequently Asked Questions
Q: Is there any problem in executing reboot twice when applying the OpenBoot
PROM firmware?
There is no problem.
To Next Page
Loading...
Need help?
General
