Sun Microsystems Sun SPARC Enterprise M4000 User Manual

5-14 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
showntp / showdate
The showntp(8) command displays the NTP server configured with the server. The
showdate(8) command displays the system standard time (XSCF time). The system
administrator can use the showdate(8) command to determine the reference time
used in the server.
showstatus
The system administrator can use the showstatus(8) command to list degraded
components.
5.5 Domain Control and Maintenance
Commands
This section describes the typical XSCF Shell commands that manage resource
assignment to domains and resource removal from domains, install devices, remove
devices, replace devices, and enable or disable functions.
■ showdevices / cfgdevice
■ console
■ showdcl / setdcl
■ showfru / setupfru
■ addfru / deletefru / replacefru
■ showboards / addboard / deleteboard / moveboard
■ showdomainmode / setdomainmode
showdevices / cfgdevice
The cfgdevice(8) command displays the domain to which a DVD drive unit or
tape drive unit is assigned. Also, the cfgdevice(8) command can be used only on
M8000/M9000 servers. The showdevices(8) command displays the operating status
of resources installed on a system board (XSB). The system administrator can use
this command to determine the devices to be assigned to a domain and check
whether the DR function can be used to connect or disconnect an XSB.

Sun Microsystems Sun SPARC Enterprise M4000 Specifications

General

Brand	Sun Microsystems
Model	Sun SPARC Enterprise M4000
Category	Server
Language	English