Chapter 9 How to Use the XSCF Web 9-15
TABLE 9-9 lists the functions for the domain configuration. Select
[Operation]-[Domain Configuration]-[Domain Configuration] in the Menu tree.
TABLE 9-9 Domain Configuration
Function Remarks
Domain configuration information display (DCL) Displays the DCL information for a system board
in the specified domain, and sets the configuration
policy for the domain.
These functions are equivalent to the
showdcl(8)and setdcl(8) commands.
In the M3000 server, the information for domain ID
0 is displayed and only the configuration policy
can be set.
Configure the DCL information Sets the DCL information. Specify configuration for
the LSB of a specified domain.
This function is equivalent to the setdcl(8)
command. For detail of configuration information,
see
TABLE 2-22.
In the M3000 server, this function is not available.
XSB addition, deletion, and movement Specifies the XSB configuration modification to the
domain as below.
• Assign or configure a system board to a domain
• Delete a system board from a domain
• Move a system board form one domain to
another
These functions are equivalent to the addboard(8),
deleteboard(8), and moveboard(8) commands.
Please operate as well as the procedure in
Section 2.2.11, “Domain Configuration” on
page 2-94.
When you use the DR function, also run the
procedure in the Dynamic Reconfiguration User’s
Guide.
In the M3000 server, this function is not available.
To Next Page
Loading...
Need help?
General
