Chapter 2 Setting Up XSCF 2-11
19. Configure the Locale settings.
20. Configure the Altitude Administration settings.
Note – Normally, the Altitude Administration is set up by FE. Also, the privilege of
fieldeng is required.
21. Configure the DVD drive/tape drive unit settings.
22. Configure the capacity on demand (COD) settings.
Note – In the M3000 server, COD is not available.
2.1.2 Setup Summary Using the XSCF Web
This section describes the setup summary using the XSCF Web. This procedure
contains examples of the windows that are used. For details on settings, see the
corresponding parts of Section 2.2, “Specifying the XSCF Settings” on page 2-14.
• Display and set the Locale. showlocale(8), setlocale(8)
(See Section 2.2.14, “Locale Administration”
on page 2-136)
• Display altitude settings and configure
altitude.
showaltitude(8), setaltitude(8)
(See Section 2.2.15, “Altitude
Administration” on page 2-137)
• Display DVD drive/tape drive unit
information, including connection
information, and configure the devices.
cfgdevice(8)
(See Section 2.2.16, “DVD Drive/Tape Drive
Unit Administration” on page 2-138)
• Display and set the COD. showcodlicense(8), addcodlicense(8),
deletecodlicense(8), showcod(8),
setcod(8), showcodusage(8)
(See Section 2.2.17, “COD Administration”
on page 2-141)
To Next Page
Loading...
Need help?
General
