Chapter 4 Operation of the Server 4-13
Note – Only the domains that are able to be powered on are displayed.
4.4.2 System Power Off
■ Command operation
1. Use the showdomainstatus(8) command to check the power status of the
system.
2. Use the poweroff(8) command to turn off power to all domains.
XSCF> poweron -a
DomainIDs to power on:00,01,02,03
Continue? [y|n] :y
00 :Not powering on: The power supply has already been turned on.
01 :Powering on
02 :Powering on
03 :Powering on
*Note*
This command only issues the instruction to power-on.
The result of the instruction can be checked by the
"showlogs power".
XSCF> showdomainstatus -a
DID Domain Status
00 Running
01 Running
02 Running
03 Running
To Next Page
Loading...
