Chapter 2 Setting Up XSCF 2-65
6. Use the sethttps(8) command to enable https.
7. Use the rebootxscf(8) command to reset the XSCF.
■ After the XSCF reset, the XSCF session is disconnected. Please log in again to the
XSCF.
8. Access the XSCF Web specifying the https form client. In the window, please
check that the security warning dialog is not displayed or confirm whether the
certificate is correct.
XSCF> sethttps -c enable
Continue? [y/n] :y
Please reset the XSCF by rebootxscf to apply the https settings.
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n] :y
To Next Page
Loading...
