4-16 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
2. Use the poweroff(8) command to turn off power to the specified domain.
Note – If the poweroff(8) command is performed, and the shutdown has
completed, then the domain is powered off.
Caution – IMPORTANT - See the following paragraphs for important information
about the domain power-off procedure.
â– When Solaris OS of the domain is being booted, the power cannot be turned off.
After Solaris OS booting is completed, execute the poweroff(8) command again.
â– When Solaris OS of the domain is running in single user mode, the power cannot
be turned off using the poweroff(8) command. Execute the shutdown(1M)
command on the domain.
Note that when Solaris OS of the domain is running, domain power-off (shutdown
-i5, or equivalent) is required.
<Example 1> Turn off power to the specified domain.
XSCF> poweroff -d 1
DomainIDs to power off:01
Continue? [y|n] :y
01 : Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the
"showlogs power".
<Example 2> Cancel domain power off in progress.
XSCF> poweroff -d 1
DomainIDs to power off:01
Continue? [y|n] :n
<Example 3> Forcibly turn off power to a domain.
XSCF> poweroff -f -d 1
DomainIDs to power off:01
The -f option will cause domains to be immediately reset.
Continue? [y|n] :y
01 :Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the
"showlogs power".
To Next Page
Loading...
Need help?
General
