Chapter 5 Overview of the XSCF Shell 5-5
showfru Displays the specified number of XSB partitions of the system board and the
memory mirror mode that is set.
testsb Diagnoses the system board.
addboard Adds a system board to a domain.
deleteboard Deletes a system board from a domain. Alternatively, it reserves a delete to the
system board. If the deletion is reserved, the deletion is done after Solaris OS reboot.
moveboard Moves a system board to another domain. Alternatively, it reserves a move to the
system board. If the movement is reserved, the deletion is done after Solaris OS
reboot of source domain, and the assignment to the new domain is done.
replacefru Replaces a CPU/Memory Board unit, I/O unit, fan unit, PSU, or XSCF Unit in work
performed according to the applicable guide.
addfru Installs a CPU/Memory Board unit, I/O unit, fan unit, or PSU in work performed
according to the applicable guide.
deletefru Removes a CPU/Memory Board unit or I/O unit in work performed according to
the applicable guide.
setdomainmode Sets a hardware initial diagnostic level (No, standard, maximum).
Enables or disables break signal sending, host watchdog, automatic boot, and sets
CPU operation mode.
showdomainmode Displays the domain host ID, the hardware initial diagnostic level, information of
enabled or disabled status on break signal sending, Host watchdog, automatic boot,
and displays CPU operation mode, ethernet address (mac address).
sendbreak Sends a break signal to the server.
showresult Displays the exit status of the most recently executed command.
setlocale Sets locale.
showlocale Displays locale.
setaltitude Sets altitude.
showaltitude Displays altitude.
cfgdevice Sets the connection destination of the DVD drive unit and tape drive unit. Displays
the setting status information.
addcodlicense Applies the obtained COD license key to the system.
deletecodlicense Deletes the license key applied to the system.
showcodlicense Displays the license keys applied to the system.
showcodusage Displays license usage information.
setcod Configures COD settings.
showcod Displays COD settings.
TABLE 5-1 XSCF Commands (Continued)
Command Description
To Next Page
Loading...
Need help?
General
