2-4 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
When the server is running normally, the mode switch is set to the Locked position.
2. Set the password policy.
(This table includes the example of setting items and command used. It is similar
thereafter.)
3. Create an XSCF user account, password and privileges.
■ Create at least one user account with the user privileges of platadm and useradm:
(The screen is an operating procedure image.)
■ The default user account is publicly available information. When installation is
completed, create an appropriate user account for the user environment and log
in again with the new user account. For details on the user privileges, see the
Administration Guide.
■ When you add the user account, use the showuser(8) command with -l option
to confirm that there is no illegal user account in the user account list.
Note – In preparation for maintenance work, please create an account for a field
engineer (FE) with the privilege of fieldeng during the initial set up.
login: default
Change the panel mode switch to Service and press return...
(Operation : Locked state -> Service -> Return)
Leave it in that position for at least 5 seconds. Change the panel
mode switch to Locked, and press return...
(Operation : Wait more than 5 seconds -> Service state ->
Locked -> Return)
XSCF>
• Display and set a password policy. showpasswordpolicy(8),
setpasswordpolicy(8)
(See Section 2.2.2, “User Account
Administration” on page 2-31)
XSCF> adduser yyyy
XSCF> password yyyy
XSCF> setprivileges xxxxxx
(See Section 2.2.2, “User Account Administration” on page 2-31)
To Next Page
Loading...
Need help?
General
