2-22 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
In the M8000/M9000 servers, subsequently to the XSCFU#0 side, specify the host
name and the routing of the XSCFU#1 side. (See showhostname(8),
sethostname(8), showroute(8), setroute(8), shownameserver(8), and
setnameserver(8).)
6. Apply network settings.
(See applynetwork(8), rebootxscf(8).)
Note – An XSCF reset or failover might prevent any of the setting commands
operation from completing. If a reset or failover occurs during the setting operation,
log in to the active XSCF to determine if the operation succeeded. If not, try it again
Enabling or Disabling the XSCF Network and Specifying an IP Address
and Netmask for the Network and DSCP
â– Command operation
1. Use the shownetwork(8) command to display network interface information.
To Next Page
Loading...
Need help?
General
