Sutter Instrument P-1000 - Page 12

P-1000 FLAMING/BROWN MICROPIPETTE PULLER SYSTEM OPERATION MANUAL – REV. 3.02 (20161118)
x
Figure 4-26. Sample program.................................................................................................................. 45
Figure 4-27. Pull cycle report (multiple-loops). .....................................................................................45
Figure 4-28. Side view of fire polishing spacer. .....................................................................................56
Figure 4-29. Fire-polish spacer in puller bar. ........................................................................................57
Figure 4-30. Filament alignment. ........................................................................................................... 57
Figure 4-31. End view of box filament and glass................................................................................... 58
Figure 4-32. Box filament positioning. ................................................................................................... 59
Figure 4-33. End view of trough filament and glass............................................................................. 59
Figure 4-34. Trough filament positioning.............................................................................................. 60
Figure 5-1. V-Groove bearings and puller bars. .................................................................................... 61
Figure 5-2. Filament alignment. .............................................................................................................62
Figure 5-3. Micropipette shapes..............................................................................................................63
Figure 5-4. Pulley adjustment................................................................................................................. 64
Figure 6-1. Starting Diagnostics from the Main Menu screen. ........................................................... 73
Figure 6-2. Diagnostics screen.................................................................................................................73
Figure 6-3. Air pressure system diagnostics screen..............................................................................74
Figure 6-4. Heat system diagnostics screen........................................................................................... 75
Figure 6-5. Heat system diagnostics error reporting............................................................................ 76
Figure 6-6. Pull diagnostics screen. ........................................................................................................ 76
Figure 6-7. Velocity diagnostics screen. .................................................................................................77
Figure 6-8. Starting Calibrate TouchScreen from the Main Menu screen. .......................................78
Figure 6-9. TouchScreen Calibration. ....................................................................................................78
Figure 6-10. Power entry module and fuse holder................................................................................83
TABLE OF TABLES
Table 4-1. Standard factory configuration.............................................................................................33
Table 4-2. Box filament sizes...................................................................................................................59
Table 4-3. Trough filament sizes.............................................................................................................60
Table 6-1. Startup Problems Troubleshooting......................................................................................70
Table 6-2. General operational problem troubleshooting. ................................................................... 70
Table 6-3. On-screen emergency reset messages. .................................................................................70
Table 6-4. On-screen error message in Edit/Pull Screen when Ramp value is not specified. ..........71
Table 6-5. On-screen error messages in Edit/Pull screen when PULL is pressed. ...........................72
Table 6-6. Other on-screen error messages in Edit/Pull screen. ......................................................... 72