25
4. OPERATING INSTRUCTIONS
4.1 First Time Use
While we realize that most new users of the P-1000 are anxious to start pulling useable
pipettes right away, we cannot over-state the importance of taking a few moments to review
the manual in order to understand how the puller works. Many a heating filament has been
destroyed with first use due to not taking the time to understand the relationship between
the programmable heat settings and the filament installed in the puller. If you absolutely
must use the puller before reading through the manual, the following instructions are
provided to help you get going and keep you from vaporizing your heating filament.
4.1.1 Quick Start Instructions
1. Remove the rubber bands from the P-1000 puller bar knobs.
2. Plug in the puller to the power AC mains.
3. Turn the puller ON – the power switch is on the left-side panel.
4. The Startup Screen will be displayed for 5 seconds while the puller systems are checked.
S
stem Chec
Figure 4-1. Startup screen.
5. The Home Screen will appear.
Figure 4-2. Home screen.
P-1000 FLAMING/BROWN MICROPIPETTE PULLER SYSTEM OPERATION MANUAL – REV. 3.02 (20161118)
To Next Page
Loading...