Sutter Instrument P-1000 - Figure 4-3. Using the Knob or Keypad to Select a Program; Figure 4-4. Instruction to Run Ramp Test

2
6
6. Use knob or keypad to select Program # [3]. Press <ENTER> or push IN the knob to
enter Program 3.
Use keypad or knob to se
and then press <E
lect Prog. #3
NTER>
Figure 4-3. Using the knob or keypad to select a program.
7. Program 3 will now be displayed.
A
“beep” will sound and this message will
appear instructing you to run a Ramp Test.
Figure 4-4. Instruction to run ramp test.
8. Press “Ramp” on the touch-screen display to run a Ramp Test.
P-1000 FLAMING/BROWN MICROPIPETTE PULLER SYSTEM OPERATION MANUAL – REV. 3.02 (20161118)