ENGINE 3-51
CRANKSHAFT JOURNAL BEARING REPLACEMENT
• Use the special tool to replace the crankshaft journal bear-
ings. The replacement procedure is as follows.
[ 09913-60230: Journal bearing remover/installer
• Set the special tool as shown to remove the crankshaft journal
bearings.
NOTE:
Remove the crankshaft journal bearings in only one direction,
from inside to outside of each crankcase half.
• Gradually press out the bearing with the special tool by using
the hand-press.
NOTE:
Using the hand-press is recommended to remove the crankshaft
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
[ 09913-60230:
1 Jornal bearing remover/installer
09924-84510:
2 Bearing installer set
09924-74570:
3 Final drive gear bearing
remover/installer
The removed bearings must be replaced with new
ones.
Hand press
Crankcase
Bearing
Bearing
To Next Page
Loading...
