3-52 ENGINE
• Set the specified crankshaft journal bearings to the special
tool.
[ 09913-60241: Jornal bearing installer holder
• Tighten the special tool bolt to the specified torque.
! Special tool bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
* Before setting the bearing, apply enough engine oil
to the special tool and bearings.
* When setting the bearing, align the bearing side with
the engraved line
A and also the bearing edge with
the mating surface of the special tool.
Before installing the bearings, lightly shave off the
sharp edge part of the crankcase chamfer by using an
oilstone and wash the crankcase bore with enough
engine oil.
Sharp edge
To Next Page
Loading...
