ENGINE 3-53
• Set the bearings installed in the special tool to the crankcase
half as shown.
• Apply enough engine oil to the special tool and the bearings
and then set the special tool carefully.
• Gradually press in the bearing into the main journal bore by
using the hand-press until the special tool
1 or
2 stops the
special tool
3.
[
1 09913-60210: Journal bearing remover/installer
(Left crankcase)
2 09913-60230: Journal bearing remover/installer
(Right crankcase)
3 09913-60241: Journal bearing installer holder
* Be sure the bearing protruded side
A faces the
crankcase bore.
* Align the special tool mating surface with the line
mark
B on the crankcase.
Hand press
or
Bearing
Bearing
or
1
Left crankcase
2
Right crankcase
Since the journal bearing press-fitting position is dif-
ferent between the right and left crankcases, use the
correct installer respectively.
To Next Page
Loading...
