Suzuki AN650 2002 - Page 265

8-22 COOLING AND LUBRICATION SYSTEM
• Install the new mechanical seal using a suitable size socket
wrench.
NOTE:
On the new mechanical seal, the seealer
A has been applied.
• Install the rubber seal
1 into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The paint marked side
A of the mechanical seal ring faces the
impeller.
Make sure the mechanical seal ring is fit into the impeller.
• Apply grease to the impeller shaft.
W 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the impeller shaft to the water pump body.
• Install the E-ring
1 to the impeller shaft.