Engine General Information and Diagnosis: 1A-118
4) Click each button (2). At this time, if an operating sound is heard from the EVAP system purge control valve, the
function is normal.
Specifications
Service Data
B815H21107001
Injector + Fuel Pump + Fuel Pressure Regulator
FI Sensors
2
I823H1110219-01
Item Specification Note
Injector resistance 11 – 13 Ω at 20 °C (68 °F)
Item Standard/Specification Note
CKP sensor resistance 180 – 280 Ω
CKP sensor peak voltage 3.0 V and more When cranking
IAP sensor input voltage 4.5 – 5.5 V
IAP sensor output voltage Approx. 2.7 V at idle speed
TP sensor input voltage 4.5 – 5.5 V
TP sensor output voltage
Closed Approx. 1.1 V
Opened Approx. 4.3 V
ECT sensor input voltage 4.5 – 5.5 V
ECT sensor output voltage 0.15 – 4.85 V
ECT sensor resistance Approx. 2.45 kΩ at 20 °C (68 °F)
IAT sensor input voltage 4.5 – 5.5 V
IAT sensor output voltage 0.15 – 4.85 V
IAT sensor resistance Approx. 2.58 kΩ at 20 °C (68 °F)
AP sensor input voltage 4.5 – 5.5 V
AP sensor output voltage Approx. 3.6 V at 100 kPa (760 mmHg)
TO sensor resistance 16.5 – 22.3 kΩ
TO sensor voltage
Normal 0.4 – 1.4 V
Leaning 3.7 – 4.4 V When leaning 65°
GP switch voltage 0.6 V and more From 1st to Top
Injector voltage Battery voltage
Ignition coil primary peak voltage 80 V and more When cranking
HO2 sensor output voltage
0.3 V and less at idle speed
0.6 V and more at 3 000 r/min
HO2 sensor heater resistance Approx. 8 Ω at 23 °C (73 °F)
PAIR control solenoid valve
resistance
20 – 24 Ω at 20 – 30 °C (68 – 86 °F)
STP sensor input voltage 4.5 – 5.5 V
STP sensor output voltage
Closed Approx. 0.5 V
Opened Approx. 3.9 V
STVA resistance Approx. 6.5 Ω
EVAP system purge control
solenoid valve resistance
Approx. 32 Ω at 20 °C (68 °F) E-33 only
ISC valve resistance Approx. 80 Ω at 20 °C (68 °F)
To Next Page
Loading...
