1B-13 Emission Control Devices:
Installation
Installation is in the reverse order of removal.
Pay attention to the following points:
• Apply bond to the mating surface of the PCV cover.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
NOTE
• Make surfaces free from moisture, oil, dust
and other foreign materials.
• Spread the sealant on surfaced thinly to
form an even layer, and assembly the
crankcases within a few minutes.
• Fit the engine ground lead wire (1) and tighten the
bolts.
• Install the PCV reed valve.
• Connect the PCV hose securely.
Crankcase Breather (PCV) Cover Inspection
B815H21206008
Inspect the crankcase breather (PCV) cover in the
following procedures:
1) Remove the PCV cover. Refer to “Crankcase
Breather (PCV) Hose / Reed Valve / Cover Removal
and Installation (Page 1B-12)”.
2) Inspect the PCV cover in the carbon deposit. If the
carbon deposit is found in the PCV cover, remove
the carbon.
3) Reinstall the PCV cover. Refer to “Crankcase
Breather (PCV) Hose / Reed Valve / Cover Removal
and Installation (Page 1B-12)”.
Crankcase Breather (PCV) Inspection
1) Remove the PCV reed valve. Refer to “Crankcase
Breather (PCV) Hose / Reed Valve / Cover Removal
and Installation (Page 1B-12)”.
2) Inspect the PCV reed valve for the carbon deposit.
If the carbon deposit is found in the reed valve,
replace the PCV reed valve with a new one.
3) Reinstall the PCV reed valve. Refer to “Crankcase
Breather (PCV) Hose / Reed Valve / Cover Removal
and Installation (Page 1B-12)”.
I823H1120021-02
1
I815H1120019-03
I823H1120024-01
I823H1120025-01
To Next Page
Loading...
