Lighting Systems: 9B-9
2) Remove the socket (2) by turning it
counterclockwise.
3) Replace the bulb (3).
4) Reinstall the removed parts.
Reflex Reflector Construction
B815H29206017
Turn Signal / Side-Stand Relay Inspection
B815H29206018
Refer to “Electrical Components Location in Section 0A
(Page 0A-8)”.
NOTE
Make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are
OK, the turn signal relay may be faulty; therefore,
replace the turn signal/side-stand relay with a new one.
Refer to “Turn Signal / Side-Stand Relay Removal and
Installation (Page 9B-9)”.
Turn Signal / Side-Stand Relay Removal and
Installation
B815H29206019
Removal
1) Remove the left upper panel. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)”.
2
I815H1920033-01
3
I815H1920034-01
3
(a)
2
(a)
1
(b)
I815H1920035-07
1. Front reflex reflector x 2 pcs. (For E-03, 24, 28, 33) 3. Reflector bracket x 2 pcs. : 10 N⋅m (1.0 kgf-m, 7.0 lb-ft)
2. Reflector x 2 pcs. (For E-03, 28, 33) : 1.8 N⋅m (0.18 kgf-m, 1.3 lb-ft)
To Next Page
Loading...
